Free shipping on orders above 80€

Salvagiakka

The "Salvagiakka Full Optional" has the characteristic of making comfortable, stylish and dynamic each car journey and also makes practical the use of the seat belt pads. "Salvagiakka Full Optional"’s function is to eliminate the inconvenience caused by the continuous rubbing between the seat belt and all the parts that are in direct contact with it, especially preserving cloths fromexcessive rubbing. The combination and the synergy between the Pad and the special Rewinder allows to have a unique driving experience. "Salvagiakka Full Optional" wide range of colors makes it an extremely versatile and customizable accessory.

The "Salvagiakka Full Optional" has the characteristic of making comfortable, stylish and dynamic each car journey and also makes practical the use of the seat belt pads. "Salvagiakka Full Optional"’s function is to eliminate the inconvenience caused by the continuous rubbing between the seat belt and all the parts that are in direct contact with it, especially preserving cloths fromexcessive rubbing. The combination and the synergy between the Pad and the special Rewinder allows to have a unique driving experience. "Salvagiakka Full Optional" wide range of colors makes it an extremely versatile and customizable accessory.

Installation

  1. clean the surface of the inner mast of the car cabin (fig. 1)
  2. remove the film of double-sided adhesive on the back of the spherical support (fig. 2)
  3. fix the spherical support with the screw facing down above the rewinding point of the safety belt (about 2-3 cm), maintain the pressure for a few seconds ( fig. 3) (before proceeding with the installation, it is recommended to wait about two hours to optimize the grip of the special double-sided adhesive)
  4. hook the retractor to the spherical hinge pivot through the slot on the upper back side of the retractor by rotating it 90 ° (fig. 4)
  5. wrap the case to the safety belt above the tongue connector (fig 5)
  6. adjust the distance between the case and retractor through the adjusting ribbon by fixing its ends to the velcro of the case inner wing according to your personal needs and to the specific requirements of your car (fig. 6)
  7. Close the snap fasteners (fig. 7)

Use

activate

  1. fasten the safety belt and then place the case at the desired height by sliding it along the safety belt (fig. 8) 
  2. fix the case position by moving upwards the adjustment button of the retractor (fig. 9)

disactivate

  1. unfasten the safety belt; the case will return to the position previously set. If you want to return to the initial position of installation, unlock the retractor by moving downwards the adjustment button (fig. 10)

tecnico-ovojack.jpg

Hide Instructions
Read Instructions